How To Reset Oil Service Tata Zest 2017

Tata Zest Service Reset:In this tutorial I am going to tell how to reset service reminder light on Tata Zest .When sevice light spanner begin to blink on cluster meter you need to do the maintence service change engine oil and perform the service light reset.To perform this reset I am using Launch ScanplusX scanning tool.

OBD port location Tata Zest :Tata Zest OBD port is located on right side below the steering wheel.

Service Light Reset Tata Zest 2017 Model

1.Connect the VCI to OBD connector.

2.Open the “SCANPLUS APPLICATION”.

3.Click “LOCAL DIAGNOSID”.

4.Select “ASIA”.

5.Select “TATA(INDIA)”.

6.Select “ZEST”

7.Select “DIESEL”(You can select DIESELor PETROL according to your car)

8.Select “XM-1.3L SDE”(Select engine varient according to your car)

9.Select “IPC (Instrument Panel Cluster System)”

10.Select “SPECIAL FUNCTION”.

11.Select “ROUTINE TEST”.

12.Select “SERVICE REMINDER RESET”.

13.PRESS “OK” on the Routine Test condition tab.

14.PRESS “OK” on the Routine Test message.

15.Click “START”.

16.After confirmation message “Routine Completed All Request Functionality” appears click “OK”

Check cluster meter the service spanner light will disapper and service reset proceduer completed.By following these step you can reset service light on Tata Zest 2017 model by Launch Scanner.

2017 Tata Zest Engine Oil Grade And Capacity

Zest Diesel-Approximately 3.2 liter of 5W-30 grade oil when engine oil and oil filter changed.

Zest Revotron Petrol-Approximately 4 liters of 5W-30 grade oil when engine oil and oil filter changed.

Notice

Please check with owner manual for correct specification for your vehicle.Content in this post is for training purpose and to be used as guideline only.If you have any query or suggestion write in the comment section.

Thank You.

You Can Also Read :-

Leave a Comment